STMicroelectronics acc44 accelerometer sensor device driver for Google nanohub.
The driver uses the device in high-resolution mode  with FS=8g.

This drivers support following devices:
    - LIS2DW12

- Supported features:

A. Reports accelerometer data
B. Different data rates:
C. I2C protocol
D. Data ready reported by interrupt


- Platform/variant porting:

The driver requires that following macros are defined in the variant.h
file of the specific variant:

  ST_ACC44_I2C_BUS_ID    /* specify I2C Bus ID */
  ST_ACC44_I2C_SPEED     /* specify I2C Bus speed in hz */
  ST_ACC44_I2C_ADDR      /* specify device I2C address */

  ST_ACC44_INT_PIN       /* specify the gpio used for the DRDY irq */
  ST_ACC44_INT_IRQ       /* specify the exti interrupt of ST_ACC44_INT_PIN */

  ST_ACC44_TO_ANDROID_COORDINATE(x, y, z)
                         /* specify how axis has to be rotated according to variant platform
                          * orientation.
                          */

Example:

  /*
   * Define platform/variant dependent ST_ACC44 device macros
   */
  #define ST_ACC44_DBG_ENABLED 1

  /* I2C defs to be used when device is plugged to I2C bus */
  #define ST_ACC44_I2C_BUS_ID      0
  #define ST_ACC44_I2C_SPEED       400000
  #define ST_ACC44_I2C_ADDR        0x19

  #define ST_ACC44_INT_PIN         GPIO_PC(5)
  #define ST_ACC44_INT_IRQ         EXTI9_5_IRQn

#define ST_ACC44_TO_ANDROID_COORDINATE(x, y, z)   \
    do {                                        \
        float xi = x, yi = y, zi = z;           \
        x = xi; y = yi; z = zi;                 \
    } while (0)

If these macros are not defined in the current variant the driver forces a compilation
error.